How to vape
- Load Glass Aroma Tube
Put coarsely ground flower in a small container, then twist the glass tube into the container to fill the dish — be sure not to press too hard or pack it too tightly.
- Insert Glass Aroma Tube
Pre-heat unit before inserting the tube, then insert the flower filled tube into the ArGo.
- Close the Push-Top
Push down the top to expose the end of the Glass Aroma Tube for use. For protection of the tube, press the release button on the back of the unit.
- Press and Hold the (+) and (M) Buttons to Turn On
A timer will count down on the OLED screen showing the power on delay and a greeting message is displayed when the unit is powered on.
- Set the Temperature and Let Unit Heat Up
Press one of the three control panel buttons and the ArGo will start to heat up automatically.Then, press the (+) and (-) buttons to adjust the temperature in 1-degree increments, or hold the button down to adjust the temperature in 10-degree increments.
- Inhale and Enjoy
The ArGo will remain heated and ready to use until you turn the device off. Because of the convection heating method, the flower is only heated when you inhale, meaning there's virtually zero waste with this product. To turn off, hold the (M) and (-) buttons.
How to clean the ArGo
Essentially maintenance free, the ArGo is extremely easy to clean. Simply soak the glass parts in isopropyl alcohol for a couple of hours, then rise with hot water. Make sure they are fully dry before re-inserting them into the device.